PEUGEOT CityStar Serie Bedienungsanleitung Seite 39

NOTICE_CTS_EURO4_V3-04A.mif Page 9 Lundi, 6. mars 2017 10:27 10
C.Clock.
It is only possible to set the time in the total kilometres
position with the machine stationary.
• Pressing the control button (8) for more than 3 seconds
will make the two hour digits flash.
Set the time by successive pushes on the control button.
• Pressing the control button for more than 3 seconds will
make the first digit of the minutes flash.
Set the minutes by successive pushes on the control
button.
• Pressing the control button for more than 3 seconds will
make the second digit of the minutes flash.
Set the minutes by successive pushes on the control
button.
Press the control button for more than 3 seconds to
confirm the clock setting.
D.Fuel gauge. Fuel reserve gauge.
When the fuel tank is full all the segments of the fuel
gauge are lit.
The fuel reserve gauge corresponds to the two last
segments (r) which show two reserve levels.
1st level: the first two segments flash.
2nd level: the last segment flashes.
When the tank is empty, all the segments on the fuel
gauge are off and the "pump" symbol flashes (p).
If all the segments flash, the diagnostic
function has detected an anomaly on the fuel
gauge system. The system must be checked
by an authorised dealer.
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Scooters
E. Outside temperature gauge.
The temperature shown is that read on the front of the
vehicle.
The "risk of black ice" symbol comes on as soon as the
temperature falls below3°C (v).
F. Maintenance counter
-Each time the ignition is
switched on, the on-board
e
computer displays the
remaining kilometers until
the next vehicle service (m).
When the kilometers reach
zero, the maintenance
symbol is displayed on the
m
multi-function display (e).
• Frequency displayed on the service indicator:
10000 km.
This period does not include the first inspection
at 500 km and concerns normal servicing.
See service book for harsh-use servicing.
Maintenance counter reset.
- Ignition off, hold down the control button (8) and turn
on the ignition, the distance unit flashes.
- Release the settings button.
- Hold down the settings button for more than 5 seconds
to switch off the maintenance symbol and set the
maintenance counter to zero.
- Turn off the ignition.
You are advised to go to an authorised dealer
to have the vehicle serviced and the message
on the maintenance indicator erased.
FR
GB
DE
IT
ES
NL
GR
SE
PT
FI
DK
9/25