Replacement Of The Fuse - Unox LineMiss XF100 Bedienungsanweisung

UNO
2.1 REPLACEMENT OF INTERNAL LAMP
To replace the internal lamp, please operate as
follows:
- Disconnect the appliance from the power
supply system and let it cool down.
- Remove the lateral supports.
- Unscrew the glass cover and replace the lamp
with one with the same characteristics.
- Screw the glass cover back in.
- Reassemble the lateral supports.
2.2

REPLACEMENT OF THE FUSE

If the control panel is completely turned off, but
the power supply reaches the appliance, the main
reason could be a burned fuse on the power board
(placed in the back part of the oven).
To replace the fuse, proceed as follows:
- press on the cover of the fuse holder and
rotate it of about 20° counterclockwise;
- remove the cover of the fuse holder;
- remove the fuse from the cover of the fuse
holder;
- replace the fuse with one with the same
characteristics;
- insert the cover of the fuse holder in its
place;
- press the cover and rotate it of about 20°
clockwise.
2.3 REFIT OF THE SAFETY THERMOSTAT
The appliance is equipped with a safety thermostat
with manual recovery. This safety thermostat is
needed to protect the appliance from overheating.
In case it is needed, it turns the appliance off.
This safety thermostat can be reached removing the
black cap you find on the bottom part of the back
of the oven: in case you need to refit it, push the key
you have in the center of the thermostat so that it
starts working again.
ENGLISH ENGLISH
12
R
ENGLISH