Chapter 5: Use; Section 1 Start/Stop Engine - EMAK DR65HR11 Bedienung Und Wartungd

Chapter 5: Use

Section 1
Before starting any work activity,
check that there is enough fuel in the
tank (10). Use a funnel with a net filter
when topping up fuel, to prevent any
impurities from entering the tank.
STOP :
Never top up the vehicle with fuel
while the engine is going.
Successively, check the oil level of
the engine using the appropriate bar
(11) positioned at the rear end of the
engine. When working on slopes,
make sure the oil is at the maximum
level in order to warrant a correct and
optimal lubrification.
When topping up oil, only use ESSO
UNIFARM 15-40 W oil. For further
information,
instruction booklet of the engine.
STOP :
Do not mix different kinds of oil, or
oils with different densities. Use only
and exclusively the oil the builder of
the engine suggests.
Before starting the flail mower make
sure you:
- put the gear Lever in neutral (N, Fig.
5.1) for your own safety.
- put the vehicle (2) and blade rotor
(6) levers in their vertical position, for
your own safety.
Start/stop engine
please consult the
19
(N)
Fig. 5.1
10 11
Fig. 5.2
6 2
Fig. 5.3
12