Simplified Eu Declaration Of Conformity; Installation - urmet 1093/181WM1 Schnellanleitung

2

SIMPLIFIED EU DECLARATION OF CONFORMITY

Hereby, URMET S.p.A. declares that the radio equipment type: camera 1093/181WM1 is in
compliance with Directive 2014/53/EU.The full text of the EU declaration of conformity is available at
the following internet address: www.urmet.com
3

INSTALLATION

It is advisable to proceed as follows for correct camera installation and configuration:
1. Make sure that no units are powered before starting the installation procedure.
2. Remove the protection dome by unscrewing with the provided spanner the 3 locking screws.
Make 3 fixing holes (for false ceiling mounting, make also a 15mm diameter hole for
passage of cables), using the minidome as drilling template.
3. Fix the minidome to the surface.
4. Ad just lens angle, slant and rotation, in order to capture correctly the selected image.
Important note:
Don't rotate the lens more than 360° in order to avoid the cut of the cables.
5. It is advisable to install and configure one camera at a time if you are installing multiple
cameras on the same network.
6. Connect the camera to the network (see section 4.1 or, alternatively, section 4.2) and assign
a static IP address (see section 4.3).
7. Fix the protection dome to the minidome base, by screwing ¼ turn about.
8. It is advisable to check that the WiFi signal received by the camera is higher than or equal
to 60.
9. Check that the frame and the zoom level (for autofocus cameras) is correct. Adjust the
bracket again and lock it in its final position.
10. If you are using a NVR/HVR device, use the NVR/HVR menu to add the camera to the
recording.
10
FIXING HOLES
°
75
DS1093-558