Cisco Linksys WRT54GS Kurzanleitung Seite 7

Save Settings button to apply
your changes.
L
Power your broadband modem
off and back on again.
M
Restart or power on your PCs so
they can obtain the Router's
new settings.To test the Router's
settings, open your web browser
from any computer. In the
browser's Address field, enter
www.linksys.com/registration
and press the Enter key.
Congratulations! The installation of
the Wireless-G Broadband Router
with SpeedBooster is complete.
If you need to set up wireless
security, proceed to the next
section.
Once the Router is
IMPORTANT:
configured, wireless security,
either WEP or WPA, should be
configured to prevent security
breaches in your network.
NOTE: If your wireless adapters
support Secure Easy Setup (SES), you
can use the SES button on the Router
to set them up.
To do this: Press the orange Cisco logo
on the Router's front panel for at least
two seconds. Wait about 10 seconds.
When the logo turns white and begins
to flash, press the adapter's
SecureEasySetup button. The Router's
Cisco logo will stop flashing when the
device has been added to the
network. Repeat this procedure for
any additional SecureEasySetup
device.
Refer to the User Guide for further
instructions.
7