Seite 1
���[]] Vorsprung durch Design und Qualität Montagehinweis für Hängetypen 1. Legen Sie an der Wand die Oberkante und seitliche Position des Hängeelementes fest und markieren diese. 2. Zeichnen Sie die Position der Keilleiste wie in der Skizze dargestellt an und bohren diese (D = 8mm). 3.
Seite 2
���[]] Vorsprung durch Design und Qualität Assembly instructions for hanging cabinets 1. Decide where you will put the hanging unit and mark the top and side edge on the wall. 2. Mark the position of the wedge gip as described in the drawing below and drill the holes with a 8mm drilling bit. 3.