Operation; Opening/Closing Sliding Gate - Normal Use; Open /Close Sliding Manually; Motor/Gate Unlocking - Heras HMD Basic HMD24 Betriebshandbuch

3

OPERATION

3.1

OPENING/CLOSING SLIDING GATE - NORMAL USE

The gate can be operated using pulse operation, for instance via a button or key switch. The
location of the operating device depends on the customer's choice or the operating mode.
 OPEN:
Press the "Open" button.
 CLOSE:
Press the "Close" button.
 STOP:
Press the "Stop" button.
3.2

OPEN /CLOSE SLIDING MANUALLY

In an emergency, the gate can also be operated from the drive unit. To do this the cover of the
motor unit must be opened.
EN Rev.: 05 September 2017 – short version -
The gate slides open to the next end position. This
can be completely or partially open (if the "Partially
open" function has been programmed).
The gate closes completely.
The gate will stop immediately, irrespective of its
direction of travel. To restart the gate press "Open"
or "Close".
3.2.1

Motor/gate unlocking

 Unlock the cabinet
 Lift the hood vertically off
 Pull the knob and turn it slightly to the left or right
 The motor falls down and the gate is manually
operated. Close the cabinet again.
Illustration 3: unlocking motor and gate
3.2.2

Locking the motor/gate

 Unlock the cabinet
 Lift the hood vertically off
 Turn the knob back as shown in the illustration
 Lift the motor until the pin falls in the hole again
 Close the cabinet, the gate is now electrically operated
again
Illustration 4: locking motor and gate
12