Safety; Explanation Of The Symbols; Safety Distances; General Safety Instructions - Heras HMD Basic HMD24 Betriebshandbuch

2

SAFETY

2.1

EXPLANATION OF THE SYMBOLS

Caution: To prevent personal injury, you must observe the safety instructions
below.
Note: To prevent material damage, you must observe the safety instructions
below.
Information: This is followed by further information or by a reference to other
documents.
Warning: Risk of limbs getting crushed
Warning: Risk of injury to hands by gear wheels
2.2

SAFETY DISTANCES

Safety distances apply for the area into which the gate slides in accordance with
EN 12445 4.1.1.1 for electrically driven sliding gates.
2.3

GENERAL SAFETY INSTRUCTIONS

 The operator must read the entire user manual before the gate is used for the first time.
The instructions stated in the user manual must be observed and complied with. All
other forms of use can cause unexpected hazards and are forbidden.
 It is forbidden to apply the drive unit to gates other than those stated in this manual,
without Heras' permission.
 Applying a third-party drive unit and/or safety edge may affect safety and will invalidate
the CE mark.
 The gate must only be put into use if all safety facilities are in place and connected, and
work properly.
 All faults which might present a source of danger to the user or to third persons must be
eliminated immediately.
 All warnings and safety notices on the equipment must be in place and clearly legible at
all times.
 Closing the gate infill openings in any way, such as by means of banners, advertising
signs etc, is not allowed as this may negatively affect the safe operation of the gate.
 All alterations or extensions to the gate must be carried out by qualified personnel using
EN Rev.: 05 September 2017 – short version - 8