Safety Provisions Employed; Intended Use - Heras HMD Basic HMD24 Betriebshandbuch

parts which the manufacturer has defined as suitable for such alterations or extensions.
Any failure to comply with these instructions will be considered as non-compliant
behavior and will invalidate the manufacturer's guarantee, as a result of which the risk
entirely transfers to the user.
For a double sliding gate, it is strictly forbidden to remove the central slam support

(mounted on the floor in the opening). This is important for the stability of the gate when
closed.
 Improper usage or servicing or ignoring the operating instructions can be a source of
danger for persons, and/or result in material damage.
If the meaning of any part of these installation and operating instructions is not clear,

then please contact your supplier before you use the equipment.
 The control system may only be installed and commissioned by specialist personnel
familiar with its operating instructions and the currently applicable health and safety at
work regulations as well as the accident prevention regulations. The instructions and
notes in the manual MUST be observed and complied with.
2.4

SAFETY PROVISIONS EMPLOYED

 To protect people and goods from injury or damage, the gate is fitted with safety
provisions including safety edges and/or photocells.
These serve as emergency provisions that immediately stop and reverse the movement
of the gate. It is forbidden to use these provisions to stop the gate normally.
 For a gate with hold-to-run control, the above-mentioned safety provisions are not
necessary and will therefore not be standard provisions.
With this type of operation, the gate stops immediately as soon as the switch is
released.
2.5

INTENDED USE

The gate is intended to control access to a specific plot, premises or site. The gate is intended
for both industrial and private use.
The gate drive and control unit is adjusted to the options agreed with the user. The
relevant options are laid down during hand-over.
Carefully read this user manual before operating the gate. You must always be familiar with the
operating mode the gate is in.
EN Rev.: 05 September 2017 – short version - 9