carrying out maintenance under the gate at the drive unit cabinet.
To move the gate manually, first switch the automatic fuse in the drive unit cabinet
to "off" and make sure it cannot be switched on again (e.g. by locking the cabinet).
The EN 12453 standard must be taken into consideration during installation and
maintenance. To achieve a good safety level, the above standard and the national
regulations must be taken into account in non-EC countries.
The Delta gate has highly tensioned cables fitted in the bottom rail. If these
cables are damaged, they can snap with great force. This can lead to serious
injury. Therefore, it is prohibited to drill into or grind these rails.
!! Only people trained by Heras are allowed to disassemble the bottom rail.
If the gate is damaged, always contact the supplier for an inspection.
Illustration 2: Warning sticker bottom rail
EN Rev.: 05 September 2017 – short version -
11