Conformity With European Directives; Delivery; General Information Regarding The Electrical Connections - Heras HMD Basic HMD24 Betriebshandbuch

A qualified person is, according to EN 12635, a person who has the required training, qualified
knowledge and practical experience required to install, test and maintain a sliding gate system
correctly and safely.
1.5

CONFORMITY WITH EUROPEAN DIRECTIVES

The installation complies with the following EU Directives/ regulations:
2006/42/ EC Machine Directive
2014/30 EU EMC Directive (electromagnetic compatibility)
305/2011 EC Construction Product Regulation
The design and production has been executed compliant with the applicable product standard EN
13241-1 and the underlying standards EN 12604, EN 12605, EN 12453, EN 12445, EN 12978 and
12635.
A Declaration of Performance (DoP) and Declaration of Conformity (DoC) are obligatory for this
product. The DoP and DoC are included in Appendix A.
The CE mark is located on the rear of the bottom rail of the gate.
1.6

DELIVERY

The sliding gate and the gate drive and control unit must be installed, connected, set up and
tuned by a fitter or an engineer who also connects and programs any accessories. The gate
control unit is adjusted to the options/accessories agreed with the user. The relevant options are
laid down during hand-over.
Of course, you can add optional/accessories afterwards. Contact your supplier for this.
Gates are always delivered fully tested.
1.7

GENERAL INFORMATION REGARDING THE ELECTRICAL CONNECTIONS

Electrical connections must be made compliant with the supplied wiring diagram.
It is important that the system is correctly earthed (Protective earthing in accordance with DIN
VDE). Earth the ring terminal with a 16 mm2 cable to an earth electrode.
Because EMC-related suppressors can leak current to the earth cable, it is advisable that you
do not protect the control unit with a Residual Current Device. When switching on the system, a
high starting current can be generated due to the charging of the intermediate circuit.
EN Rev.: 05 September 2017 – short version - 6