Rewinding Empty Spools; Maintenance - Toro 51349 Gebrauchsanleitung

POTENTIAL HAZARD
An improperly installed cap or spool could
fly off trimmer.
WHAT CAN HAPPEN
Contact with a thrown spool or cap could
cause injury to operator or bystanders.
HOW TO AVOID THE HAZARD
Be sure spool and cap are fully secured
before operating the unit. Replace spool if it
is damaged or if cap does not securely snap
onto cutter head.
Keep bystanders and pets away from
trimming area.
7. If line should tangle or break at eyelet, unplug
trimmer, remove spool, refeed the line through
eyelet, and reassemble spool to trimmer.
Rewinding Empty
Spools
To rewind an empty spool, follow the steps below:
1. Hook one end of line into slot on spool,
allowing no more than 1/8" to protrude. Push
end of line all the way to the inner end of slot.
Wind line in direction of arrow on spool in level
rows between spool flanges (Fig. 17).
Note: Trimmer will not function properly
if line is wound in the wrong
direction or if end of line protrudes
more than 1/8" at inner end of slot.
2. Do not wind line beyond outer edges of spool;
trimmer will not function properly.
GB–9

Maintenance

POTENTIAL HAZARD
There is the possibility that trimmer could
be inadvertently started when the extension
cord is plugged into an electrical socket.
WHAT CAN HAPPEN
Inadvertent starting could cause personal
injury to operator or bystanders.
HOW TO AVOID THE HAZARD
Always be sure your trimmer is unplugged
and the cutting head has stopped rotating
before attempting any maintenance or
repairs.
1. To keep the exterior clean, just wipe it off with a
damp cloth. Never hose it down.
2. Wipe or scrape clean the cutter head and spool
area any time there is an accumulation of dirt or
cuttings.
3. Check and tighten all fasteners. If any part is
damaged or lost, repair or replace it.
4. Scrape debris away from air intake vents in both
sides of motor housing (Fig. 18).
Important: Keeping air intake vents free of grass
and debris prevents motor overheating
and possible failure.
Important: To avoid damaging shield when
storing trimmer, rest trimmer on
cutter head or motor housing or
hang trimmer from handle(s). DO
NOT REST TRIMMER ON GRASS
SHIELD AS SHOWN (Fig. 19).
THE GRASS SHIELD MAY WARP
AND INTERFERE WITH
CUTTING LINE.
5. Any other servicing should be performed by an
authorized Toro Service Dealer.