Sound Emissions; Vibration Level - Toro 51349 Gebrauchsanleitung

17. Use only in daylight or with good artificial light.
Always be sure of your footing. Keep a firm
hold on the handle and walk, never run.
18. Stop the motor and unplug the supply cord
whenever you leave the appliance, before
cleaning the housing, and when making any
repairs or inspections.
19. When not in use, store your trimmer in a dry
place; high or locked up out of the reach of
children.
20. Keep all fasteners tight to be sure the appliance
is in safe working condition.
21. Make sure spool and cap are properly secured
before operation.
22. Never operate without factory installed guards or
other protective safety devices in place.
23. Do not put hands or feet near or under rotating
parts. Keep clear at all times.
24. If the appliance should start to vibrate
abnormally, stop the motor, unplug the cord and
check immediately for the cause. Vibration is
generally a warning of trouble.
25. Do not operate your appliance after it has been
dropped or damaged. Return it to your nearest
Authorized Toro Service Dealer for inspection or
repair.
26. When servicing use only identical TORO
replacement parts. Replace or repair damaged
cords.
GB–3
27. Don't Overreach—Keep proper footing and
balance at all times when operating the trimmer.
28. Maintain Appliance With Care—Keep cutting
head and motor housing clean for best
performance and to reduce the risk of injury.
Follow Maintenance instructions on page 9.
29. CAUTION—Cutting knife on grass shield is
sharp and care should be taken when cleaning
and handling.
30. EXTENSION CORD REQUIREMENTS—Use
an extension cord suitable for outdoor use and
one that complies with requirements specified in
your country's electric code. Make sure your
cord is in good condition; if damaged, replace.
Use a cord that is large enough to carry the
current the trimmer will draw.
See Figure 7 for proper cord connection.
Note: Use of an extension cord over 150 feet
is not recommended.
Certified to CEE 10

Sound Emissions

This unit has a maximum airborne noise emission,
based on measurement of identical machines.
70 dB(A)

Vibration Level

This unit has a maximum vibration level of 8.5 m/s ,
based on measurement of identical machines.