PNI ESCORT HP 62 Benutzerhandbuch Seite 4

EN
g. DW: DUAL WATCH function
h. PS: The Power Save function is active. If no key is pressed for 5 seconds, the radio enters the power
saving mode.
i. Low (Low Power) function is active
j. The received signal strength and the power of the transmitting signal
k. RX / TX: TX = transmit mode; RX=received mode
l. Frequency band selected
m. ASQ function available
9. EMG key: briefly press this key to enter emergency mode 9/19; the EMG icon will blink
10. A / F-LCR key: to select AM or FM mode; the modulation you are setting will be displayed on the
screen. If you select a frequency that operates only in the FM band, the A/F-LCR key will activate the
Last Channel Recall (LCR)
11. Microphone: During the broadcast, hold the microphone at a distance of 4 cm from the mouth and
speak using a normal tone of voice.
12. RFG Key: briefly press this key, on the screen "R 00" will show up; "00" will flash. Press the Q.UP /
Q DONW keys to select one of the 9 levels (00, 06, 12 ... 54); press this button again to confirm and exit.
Note: We recommend to disable RFG function (or level 06 for louder areas).
13. Lock key: It allows you to lock the keyboard, thus avoiding accidental use of the keys.
14. Q.UP-Q.DOWN keys: To skip 10 channels up (Q.UP) or 10 channels down (Q.DOWN)
15. Loudspeaker
16. Dual Watch: This function allows the synchronization on two different channels at the same
time.Thanks to this function, you can monitor a second channel. When a signal on the second channel
is received, the conversation on the first channel is automatically interrupted and the receiver switches
on the second channel. The monitoring starts again 4 seconds after the signal end.
TO activate this function, operate as follows:
- Select the desired channel through the channel selector
- Press the DW button
- Select the second channel
- Press the button DW again
- To cancel the function press again the DW button or the PTT button
17. SCAN key: you can automatically search for a busy channel
• Turn the squelch clockwise until the background noise is no longer heard.
• Press the "SCAN" button: the transceiver will scan automatically all the channels until a carrier is
being received.
• When it finds the carrier, it stops and starts again some seconds after the end of the communication
on the channel.
• When the radio is transmitting, the scan function is deactivated.
18. Key : when in the SQ mode short press this button, turn on the background ligh, short press this
button again, to turn off the ligh, long press this button will enter ASQ, in ASQ mode, short press the
button to turn on the background ligh and short press again will turn off the light.
19. Push to talk button (PTT): Its pressure activates the transmission. When it is released, the receiver
is activated.
20. Hole for wrist belt
21. Channel UP: To skip to the next channel. Keeping this button pressed, the "auto-repeat" function is
obtained.
22. Channel DOWN: To skip to the previous channel. Keeping his button pressed, the "auto-repeat"
function is obtained.
23. Contact for power adapter and external antenna. Pull the button up to remove the adapter.
4