Operating Mode; Status System Fan; Display Air Flowrate - ubbink Ubiflux W180 Installationsvorschriften

Display layout

6.2 Operating mode

In operating mode, the display may simultaneously show 4 dif-
ferent situations/values.
1 = Status fan mode, shows coupled appliances (see
§ 6.2.1)
2 = Air flowrate (see § 6.2.2)
3 = Message text e.g. text filter condition, activation external
switch contact etc. (see § 6.2.3)
4 = Fault symbol (see § 8.1 and § 8.2)

6.2.1 Status system fan

This part of the display shows a fan symbol together with
a number.
When the supply and exhaust fans are running, the fan
symbol is displayed. When the fans are stopped, the fan
symbol is not visible.
The number behind the fan symbol indicates the fan mode.
Refer to the table below for an explanation of the numbers.
Status fan
Description
mode on display
The supply and exhaust fans are running at 50 m
This situation depends on the setting of step number 1 (see chapter 13)
The supply and exhaust fans are running under mode 1 of the multiple switch.
1
The air flowrate depends on the setting of step number 2 (see chapter 13).
The supply and exhaust fans are running under mode 2 of the multiple switch.
2
The air flowrate depends on the setting of step number 3 (see chapter 13).
The supply and exhaust fans are running under mode 3 of the multiple switch.
3
The air flowrate depends on the setting of step number 4 (see chapter 13).
This Ubiflux is linked through eBus.
The supply and exhaust fans of the Ubiflux are running under the switched mode of the ventilation mode
"master" Ubiflux; in addition, (only for cascade connection) the display shows the "slave" number of the
□
relevant Ubiflux.
The air flowrate depends on the set step numbers "master" Ubiflux.
With application of a 3-way switch, mode
1)
6.2.2 Display air flowrate
This shows the air flowrate setting of the supply or exhaust
fan.
When when the air flow rates of the supply and exhaust
fans differ, for instance when using an external switch con-
tact, in all cases the highest air flow rate is shown.
When the appliance is switched off through software, the
text "OFF" appears here (see §7.1).
/h or they are stopped.
3
cannot be used.
Ubiflux W180 / W180+
Chapter 6
1)
15