Orascoptic Zeon Endeavour series Handbuch Seite 8

Connecting Zeon Endeavour Series to a Loupe
Through-The-Lens (TTL)
1. Secure the LED headlight assembly to the mounting
block by placing the jaw clamp onto the mounting
block and tightening the thumb screw (Figure 3).
Note: If a mounting block is not attached to the bridge
of your loupe frame, attach it using the instructions
provided with your loupe connection kit.
Mounting block
2. Secure the cable to the temple arm using the supplied temple clip(s) (Figure 5).
3. After the LED headlight is connected to your loupe, place the loupe on your head and adjust it to a comfortable
working position.
4. Secure the cable with the gown clip so that the cable does not hinder the view of the work of the user.
5. Connect the LED headlight cable to the battery pack at the LED connection point on the top of the battery pack (Figure 6).
NOTE: When using the LED headlight, or when storing the unit, never bend the cable tightly to avoid damaging the cable.
Temple clip
10
INSTRUCTIONS FOR USE
Jaw clamp
Figure 3
Figure 5
Zeon Endeavour Series
Flip-Up
1. Secure the LED headlight assembly to the hinge
assembly by placing the connector (attached to the
LED headlight assembly) onto the hinge (Figure 4).
Connector
Hinge assembly
LED connection point
Figure 4
Figure 6