Eizo DuraVision FDX1502NT Installationshandbuch Seite 13

2.
Install the monitor in the network environment.
• "To make a link using a wired LAN" (page 11)
• "To make a link to the wireless LAN using the Access Point mode" (page 11)
• "To make a link using an existing wireless LAN" (page 12)
●
To make a link using a wired LAN
Installation example
1. Connect the network cable to the LAN port of the monitor and to the Ethernet hub.
Note
• The Ethernet hub is used to link the monitor and other network devices via a wired LAN.
In the network environment where the monitor is to be installed, if an Ethernet hub or broadband router with free
LAN ports exists, the monitor can be connected to one of the free LAN ports. It is not necessary to install a new
Ethernet hub.
2. Plug the power cord into a power outlet and the power connector on the monitor.
3. Check that CONNECT LED on the side of the monitor flashes in green, that ALERT LED is off, and that
Link LED at the bottom lights up.
Note
• When the wired LAN connection is established at the 1000BASE, Link LED lights up dark orange. When the
connection is established at the 10BASE/100BASE, it lights up green.
4. Connect another network cable to the LAN port of the PC and to the Ethernet hub.
●
To make a link to the wireless LAN using the Access Point mode
Installation example
1. Connect the network cable to the LAN port of the monitor and to the Ethernet hub.
Note
• The Ethernet hub is used to link the monitor and other network devices via a wired LAN.
In the network environment where the monitor is to be installed, if an Ethernet hub or broadband router with free
LAN ports exists, the monitor can be connected to one of the free LAN ports. It is not necessary to install a new
Ethernet hub.
2. Plug the power cord into a power outlet and the power connector on the monitor.
Network cable
Ethernet hub
Network cable
Ethernet hub
Network cable
To power outlet
Power cord
To power outlet
Power cord
11