Grundfos R100 Bedienungsanleitung Seite 130

[Return to start]:
Returns to start to communicate with
another product.
[Delete all changes]:
Changes the product back to the origi-
nal setting, i.e. before communication
was started.
[Delete all changes] is not available
for all products.
[Store settings]:
Stores the product setting in the R100.
The settings will remain stored even if
the R100 is switched off.
[Store settings] is not available for all
products.
[Call up settings]:
Transfers the presetting or a stored
product setting in the R100 to the
product you communicate with.
When presetting is selected, the prod-
uct is set to the factory setting.
[Call up settings] is not available for all
products.
[Print]:
The actual data in the R100 can be
printed on a Hewlett-Packard printer,
type HP 82240B.
Point the R100 at the IR sensor of the
printer and press [OK]. All status and
operating data are then transferred to
the printer. The R100 must be pointed
at the printer as long as the following
symbol is shown:
128