DJI Snail Bedienungsanleitung Seite 9

bottom of the propellers) with the counterclockwise rotating
motors (with white dots).
2. Align gap A inside the propeller nut with fin B on the Propeller
Adapter. Press the propeller down onto the adapter firmly and,
while holding the propeller pressed down, rotate the propeller
in the lock direction (propellers marked CW rotate counter-
clockwise; propellers without markings rotate clockwise) until
you feel it secure in place.
3. To remove the propeller, press the propeller down firmly and,
while holding the propeller pressed down, rotate the propeller
in the unlock direction until it can be removed easily.
A
Other Propellers
This example uses the 6048-3D propellers. Instructions also
apply to the installation of 5048 Tri-Blade Propellers.
Tools Required: M2 hex key and Snail Propeller Adapter.
1. Remove the screws securing the Quick-Release Propeller
Adapter on the 2305 Racing Motors, and then remove the
Quick-Release Propeller Adapter.
2. Remove the cap on the Snail Propeller Adapter.
3. Align the holes of the black Propeller Adapter with the holes
on the CW motors. Insert the M2×4 screws and tighten to
secure. Align the holes of the red Propeller Adapter with
the holes on the CCW motors. Insert the M2×4 screws and
tighten to secure.
B
©
2017 DJI All Rights Reserved.
1
2
7