DJI Snail Bedienungsanleitung Seite 11

4. Launch DJI Assistant 2. When a connection is established,
the software will display the connected devices. Use your DJI
account to log in.
5. Click Settings to set parameters.
6. Click the firmware update and select the version you would
like to update. DJI Assistant 2 will automatically download
and update the firmware. Restart your ESC after the update is
complete.
Ensure that your computer is connected to the Internet during
update.
Ensure that the battery level is adequate for the update.
DO NOT unplug the USB cable during the update.
Retry to update if DJI Assistant 2 displays an update failure
prompt.
If the ESC is not recognized by the DJI ESC Assistant, check
if there is more than one FTDI device connected such as
another DJI Updater or programmer, an FTDI USB adapter
or development board (e.g. a BeagleBone, Raspberry or
Arduino board). Unplug the other FTDI devices. Restart the
DJI Assistant 2 and the ESC, and try again.
ESC Configuration
Calibrate the throttle range and switch the motor rotation
direction using the remote controller.
1. Power on the remote controller and receiver. Ensure a good
communication between them. Push the throttle stick all the
way up. The motor start a slow double beep, a single beep
sequence.
2. Then the warning sound will alternate between a quick single
beep and a quick double beep. Pull the throttle stick all the
way down after hearing a single beep to calibrate the throttle.
Pull the throttle stick all the way down after hearing a double
beep to reverse the motor rotation direction. By rotating the
desired motor quickly in any direction, this motor's rotation
direction will be changed.
3. The warning sound becomes a chime when completed.
4. Restart the ESC after reversing its rotation direction.
©
2017 DJI All Rights Reserved.
9