DJI Snail Bedienungsanleitung Seite 5

6. Only use compatible, authorized DJI parts.
7. Ensure that all parts are firmly in place and all screws are tight
before each flight.
8. The input throttle signal mode (regular or OneShot125) cannot
be changed while the product is in use. Set the input throttle
signal mode on your flight controller. Restart the electronic
speed controller to apply the new mode.
9. Do not connect the electronic speed controller to a DC
regulated power supply, or the power system and the
electronic speed controller will be damaged when the product
captures energy produced during deceleration as this product
has Active Braking Function by default.
10. Ensure that the motors rotate smoothly before takeoff.
Active Braking Function: The motor actively reverses torque
when decelerating, recovering some of the rotational energy.
Normal braking relies mainly on air resistance.
Introduction
The Snail Racing Propulsion System is a multirotor propulsion
system designed for racing multirotor aircraft with a max thrust
of 1.32kg/rotor. Based on the operation environment of racing
multirotor aircraft, impact analysis and drop tests are performed
on the Snail 2305 Racing Motor to guarantee its rugged
structure.
The Snail 430-R Racing ESC uses a 32 bit motor driver chip with
a maximum main frequency of 100MHz. Its advanced algorithms
allow a responsive motor drive with precise control and its small
power supply ripple ensures normal performance of other power
supply units when motors reach maximum current output. Like
most DJI products, the ESC firmware can be updated, ensuring
that the Snail is constantly refined.
Features
Active Braking Function
3D Mode*
Two Throttle Signal Modes
Regular throttle signal: 30Hz to 500Hz PWM signal
OneShot125 signal: 30Hz to 1000Hz
High Rotational Speed Motors
46,000rpm (7 pole pairs)
322,000rpm (1 pole pair)
©
2017 DJI All Rights Reserved.
3