Specifications - DJI Snail Bedienungsanleitung

System Status Beep Codes
The motors will beep when the Snail is in use. The table below
contains more information about the warning sound.
Alarm
Chime
Rapid Beeping
Slow Beeping
Alternating Single
and Double Beeps

Specifications

Max Thrust
Recommended Battery
Recommended Takeoff Weight 125–250g/rotor (Sea Level)
Operating Environment
ESC
Max Allowable Voltage
Max Allowable Current*
(Continuous)
Max Peak Current*(3 sec)
Supported Throttle Signal
Modes
Max OneShot125
Signal Frequency
Max Regular Signal Frequency 500Hz
Default PWM Output
Signal Frequency
Weight (Without Cables)
Supported Battery
Motor
Stator Size
KV
Weight (Without Cables)
* Tested at the temperature of 25℃, well ventilated
Propellers
5048S propellers
5024S propellers
6030S propellers
6048-3D propellers
©
10
2017 DJI All Rights Reserved.
Description
Ready to work
Minimum throttle signal not reached. Check
the flight controller, remote controller or
remote controller receiver.
No throttle signal.
Using the remote controller for configuration and
set motor rotation direction.
1.32kg/rotor (16.8V, Sea Level)
4S LiPo
-10° to 50℃
17.4V
30A
45A
Regular/OneShot125
1000Hz
16kHz
2.8g
3S–4SLiPo
23×5mm
2400rpm/V
27.8g
Diameter×Thread Pitch
5×4.8inch (12.70×12.19cm)
5×2.4inch (12.70×6.10cm)
6×3.0inch (15.24×7.62cm)
6×4.8inch (15.24×12.19cm)
Weight (single one)
5.50g
3.45g
3.20g
4.10g