Electrolux FIT2B Installations-, Wartungs-, Und Bedienungsanleitung Seite 29

E N G L I S H
6. The pump does not work.
1. The burnt-out
shows clear
melting of the
copper tube.
2. The burnt-out
shows a whitish
with little bubbles
the heating
surface.
1. Steam iron does not heat.
2. Steam iron overheating.
6. Causes:
a) The pump rotor is blocked by
scales.
b) Pump motor burned.
BOILER HEATING ELEMENT BURNT OUT
element 1. Lack of water in the boiler due
signs of to malfunctioning of the water
external level control device.
element 2. The
colour covered in scale incrustation
along stopping the heat transfer.
elements
STEAM IRON
1. Causes
a) Break of cable continuity.
b) Iron resistance burned.
c) Iron
faulty.
2. Thermostat contacts faulty.
C H A P T E R 4
heating element
thermostat contacts
Page 4-8
6. Solutions:
a) Try to operate the pump
rotor by rotating the motor
shaft by means of a screw
driver applied into the slit
on the pump motor side. If
this fails, the pump cover
must be disassembled, the
brass fan must be cleaned
and the correct
checked.
b) Replace the pump motor.
More frequent
maintenance is recommended
in the future
"MAINTENANCE").
1. Carefully check the working
of the water level control
device and
worn parts.
is 2. Proceed to clean the boiler
by removing the scale from
the interior
assembling
resistance.
More frequent
maintenance is recommended
in the future
"Maintenance")
1. Solutions:
a) Repair the electric cable
continuity.
b) Replace
resistance.
c) Replace the thermostat and
the fuse.
2. Replace the thermostat.
E N G L I S H
rotation
preventive
(See Section
replace any
walls before
the new
preventive
(See chapter
the burned