Installation - Regulation Sensor - Radson Tempco touch CP W Bedienungsanleitung

Installation – Regulation sensor
3.9.1
In this submenu you must choose the sensor which will be used for
the regulation of the room managed by this unit.
To change the sensor, press on the desired option to frame in
green the button.
Ambient:
- The main zone programmer will regulate the temperature in the
room with this internal sensor.
Floor (ext):
(external sensor is needed 10k at 25°C)
- The external sensor is used as floor sensor to regulate the
temperature of the floor.
- The external sensor is used as deported ambient sensor to
regulate the temperature of the room.
Amb. + Limit 1
- The main zone programmer will regulate the temperature in the
room with the internal sensor the external sensor is used as floor
limiter.
Press a second time on the button to view the limitation settings.
High limit: 35°C (default value)
The floor will never overpass this value.
Low limit: 18.0°C (default value)
The floor will never decrease under this value.
Amb. + Limit 2
- The main zone programmer will regulate the temperature in the
room with the internal sensor the external sensor is used as
intelligent floor limiter.
Press a second time on the button to view the limitation settings.
Floor Offset: 0°C (default value)
Offset added or subtracted to the actual setting temperature
following by the thermostat (Comfort or Reduced) , to define the
value of the lower floor limitation.
High limit: 35°C (default value)
The floor will never overpass this value.
(external sensor is needed 10k at 25°C)
(external sensor is needed 10k at 25°C)
25