Install The Hardware; Connect The Cables - Axis P1311 Installationsanleitung

AXIS P13 Series Installation Guide

Install the hardware

!
IMPORTANT! - AXIS P1311/P1343/P1344/P1346 is designed for indoor and outdoor
use. To use the camera outdoors, it must be installed in an approved outdoor housing.
Please see www.axis.com for more information on outdoor housings.

Connect the cables

1. Optionally connect external input/output devices, e.g. alarm devices. See page 18 for informa-
tion on the terminal connector pins.
2. Optionally connect an active speaker and/or external microphone.
3. Connect the camera to the network using a shielded network cable.
4. Connect power, using one of the methods listed below:
• PoE (Power over Ethernet). If available, this is automatically detected when the network
cable is connected.
• Connect an external power adapter to the power connector block, see Unit connectors,
on page 17 for wiring information.
5. Check that the indicator LEDs indicate the correct conditions. See the table on page 19 for
further details. Note that the Status LED can be configured to be unlit during normal operation.
Dimensions
Model
AXIS P1311
AXIS P1343
AXIS P1344
AXIS P1346
H x W x D
46 x 78 x 176 mm
(1.8" x 3.1" x 6.9")
46 x 78 x 192 mm
(1.8" x 3.1" x 7.6")
46 x 78 x 205 mm
(1.8" x 3.1" x 8.1")
46 x 78 x 198 mm
(1.8" x 3.1" x 7.8")
Weight
584 g
(1.29 lb)
585 g
(1.29 lb)
620 g
(1.37 lb)
630 g
(1.39 lb)
Page 5