Beta 1498TB/12-24 Gebrauchsanweisung Seite 16

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
11. When the test is completed, the display will show the set surge current, measured surge current,
voltage, internal resistance and the "life" of the battery. One of the following results will also
be displayed:
Battery: Good:
The battery is good and can hold the charge.
Battery: Recharge
The battery is flat; the battery conditions cannot be determined correctly until
the battery has been fully charged. Charge & retest battery.
Battery: To replace:
The battery will not hold the charge. It should be replaced immediately.
12. Press "EXIT" to return to step 3, or remove the test clamps from the battery posts to end the test.
GROUNDING SYSTEM TEST - "GROUNDING TEST"
1. Press ▼▲ to select the grounding system test, "Grounding Test".
Press "Enter" to confirm selection.
2. The display will appear as follows.
Clip the black clamp to the engine body or the car chassis and the red
clamp to the battery [+] post
Then press "Enter".
3. The test will take a few seconds.
4. When the test has been completed, transfer the black clamp
from either the engine or the chassis of the motor vehicle to the
battery negative post [-]. Take less than 15 seconds to complete this
procedure, not to lose the recorded data (otherwise, repeat the test).
5. After the black clamp has been connected to the negative battery
post [-], the display will appear as follows. Press "Enter" to proceed.
6. The test will take a few seconds.
7. If the measured Ohms are within limits, the display will appear as
follows.
8. If the measured Ohms are above limits, the display will appear as
follows.
9. If a wrong procedure was performed during the test, the display will
appear as follows.
16
Battery: Good
Rating: xxxA EN1
Measured: xxxA EN1
Volts:
Int. R: x.xx mΩ
Life: xx%
Battery: Recharge
Rating: xxxA EN1
Measured: xxxA EN1
Volts: xx.xx V
Int. R: xx.xx mΩ
Life: xx%
Battery: To replace
Rating: xxxA EN1
Measured: xxxA EN1
Volts: xx.xx V
Int. R: xx.xx mΩ
Life: xx%
Select Test▲▼
Battery Test
Grounding Test
Starter Test
Alternator Test
Clip black clamp
to engine body or car chassis
and red clamp to positive
battery post
Analysing...
Please wait!
Now transfer
black clamp to negative battery
post
[Enter] to proceed
Analysing...
Please wait!
Result: OK
Xx,xx mOhm
Result: High Ohms
Xx,xx mOhm
Result: Not detected
Wrong procedures.
Try again and follow given
instructions step by step.
EN I