Beta 1498TB/12-24 Gebrauchsanweisung Seite 15

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
PRINTING TEST
Once the test has been completed, if the tester is equipped with a printer, test results can be printed by
pressing the printer button after the test has been completed. If the tester is not equipped with a printer,
follow the instructions contained in the last section.
12V BATTERY OPERATING AND USE INSTRUCTIONS
1. Before testing a battery in a motor vehicle, switch off the motor vehicle as well as all the accessories
and loads. Close all the motor vehicle doors and the boot.
CAUTION: After switching off the motor vehicle engine, switch on the headlights, and leave them
on for approximately 30 seconds, so that the battery surface charge can be removed.
CAUTION: On 24V systems, test 12V batteries individually.
NB: The screen will not show anything if the tester is not connected to the motor vehicle battery.
2. Make sure that the battery terminals are clean. Clean with a metal brush, if necessary. Clamp the red
lead to the negative terminal on the motor vehicle battery. Clamp the red lead to the positive terminal on
the motor vehicle battery.
Make sure that the tester clamps and the battery posts make good contact with each other, so
that a correct test can be performed.
3. Press ▼▲ to select "New Test" or "Continue Test...". Press "Enter"
to proceed.
4. Selecting "New Test" will allow the battery "Bar code" (through the
reader*, optional accessory) and "Particulars" (e.g. customer's name)
to be entered.
* A "beep" will confirm that the code has been read.
Press "Enter" to proceed.
5. Select motor vehicle type: "Car" or "Motorcycle"
Press "Enter" to proceed.
Selecting "Motorcycle" will only allow the Battery Test to be performed.
6. Press ▼▲ to select "Battery Test". Press "Enter" to confirm
selection.
CAUTION: If any battery surface charge is detected, the tester will
remove it. If the battery surface charge is too high to be removed,
the tester will prompt you to switch on the headlights to remove it.
7. Press ▼▲ to select battery type:
a. SLI [WET type]
b. AGM-Flat plate
c. AGM-Spiral wound
d. Gel Cell
e. EFB (Start/Stop)
Press "Enter" to confirm selection.
8. Press ▼▲ to select battery test ratings CCA/
SAE,DIN,JIS,IEC,EN1,EN2, CA/MCA, Unknown
Press "Enter" to confirm selection.
9. Press ◄ ► (step of 100) ▼▲(step of 5), to enter battery surge
current.
Press "Enter" to start the test.
10. The test will take a few seconds.
New Test
Continue Test...
Bar code:
Particulars:
Car
Motorcycle
Select Test▲▼
Battery Test
Grounding Test
Starter Test
Alternator Test
Select Battery:
SLI (Wet Type)
AGM-Flat plate
AGM-Spiral wound
Gel Cell
EFB [Start/Stop]
Select Rating▼▲
CCA – SAE – DIN
JIS – IEC – EN1 – EN2 –
CA/MCA – Unknown
Input Battery Rating
Increase/decrease:
▲Single digit▼
◄By hundredth►
xxx EN1
Analysing...
Please wait!
EN I
15