Precautions - Panasonic GP-US932CSAE Handbuch

Precautions

Refer installation work to the dealer.
Installation work requires technique and experiences.
Failure to observe this may cause fire, electric shock,
injury, or damage to the product.
Be sure to consult the dealer.
Stop the operation immediately when something is
wrong with the camera.
When smoke goes up from the camera or the smell of
smoke comes from the camera, stop the operation imme-
diately and contact your dealer.
Turn the power off immediately and contact qualified ser-
vice personnel for service.
Do not attempt to disassemble this product.
To prevent electric shock, do not remove screws or cov-
ers.
There are no user-serviceable parts inside.
Ask qualified service personnel for servicing.
Do not insert any foreign objects into this product.
Failure to observe this may cause damage to this prod-
uct.
Turn the power off immediately and contact qualified ser-
vice personnel for service.
Do not use this product in an inflammable atmos-
phere.
Failure to observe this may cause an explosion resulting
in injury.
Avoid installing this product in the locations where
salt damage occurs or corrosive gas is produced.
Otherwise, the mounting portions will deteriorate and
accidents such as a fall of the camera may occur.
Do not operate this product beyond the specified tem-
perature, humidity or power source ratings.
Use this product at temperature within 0 °C to 40 °C and
humidity below 90 %. The input power source is 12 V DC.
To keep on using with stable performance
Parts of this product may deteriorate and it may shorten
the lifetime of this product when using in locations sub-
ject to high temperatures and high humidity.
Use this product at temperatures between 0 °C to 40 °C.
Failure to observe this may adversely affect the compo-
nents inside or cause this product to malfunction. Use of
this product at temperatures of 30 °C or lower is recom-
mended without direct heat from heaters in consideration
of heat release at the camera location.
Handle this product with care.
Do not abuse this product. Avoid striking, shaking, etc.
The product could be damaged by improper handling or
storage.
6
Do not aim the camera head at strong light sources.
A light source such as a spot light causes a blooming
(light bleeding) or a smear (vertical lines).
Smear
Bright subject
Blooming
Clean the main body with care.
Turn the power off when cleaning the product. Failure to
observe this may cause injury or malfunction.
Use a dry cloth to clean this product. Do not use strong
abrasive detergent when cleaning this product. When the
dirt is hard to remove, use a mild detergent and wipe
gently. Then, wipe off the remaining detergent with a dry
cloth.
Otherwise, it may cause discoloration. When using a
chemical cloth for cleaning, read the caution provided
with the chemical cloth product.
Clean the faceplate with care.
Do not clean the faceplate with strong or abrasive deter-
gents. Use lens tissue or a cotton tipped applicator and
ethanol.
To remove stubborn stains
When the dirt is hard to remove, use a mild detergent and
wipe gently. Then, wipe off the remaining detergent with
a dry cloth.
Indication label
Refer to the indication label placed on the surface of the
unit as to the indications of equipment classification and
power source, etc.
This product is intended for usage in general electron-
ics applications.
The usage of this product for special purposes, such
as traffic control instruments, transportation instru-
ments, and medical instruments, may be prohibited
without authorization under the applicable laws and
regulations of each country or region where this prod-
uct is in practical use.
The arrangement for the authorization shall be made
under customer's or user's own responsibility.