Camera Title Setting [Camera Id] - Panasonic GP-US932CSAE Handbuch

1. Camera title setting [CAMERA ID]

This item specifies the camera title. The camera title that
indicates the camera location and other information about
the camera is created with alphanumerics and symbols
and displayed on the screen. The camera title is named
with up to 16 characters.
Follow the procedure below to specify the camera title.
Top screen of SETUP menu
** SET UP **
CAMERA ID
ELC
SHUTTER
GAIN
SENS UP
OUTPUT SEL
HDMI OUTPUT
END
Title creation screen
ABCDEFGHIJKLM
NOPQRSTUVWXYZ
0123456789
().,'":;&#!?=
+-*/%$ÄÜÖÆÑÅ
← →
SPACE
*POSI RET END RESET
................
Editing area
Display positioning screen
FLOOR 1
z
Set "CAMERA ID" to "ON" and press the [SEL] button.
→ The title creation screen appears.
Note:
• Even when "CAMERA ID" is set to "OFF", pressing the
[SEL] button allows the title creation screen to
appear.
Important:
• When "CAMERA ID" is set to "OFF", the camera title
does not appear even after setting the camera title.
x
Move the cursor to the target item with use of the [g],
[h], [e] and [f] buttons, and press the [SEL] but-
ton.
→ The entered characters are displayed in the entry
range.
P1
*OFF
*OFF
OFF
OFF
OFF
RGB
YPbPr(422)
<Character entry>
• To revise a character, move the cursor to "←" or "→"
and press the [SEL] button.
Move the cursor to the character to be revised in the
entry range and reenter a correct character.
• To enter a blank, move the cursor to "SPACE" and
press the [SEL] button.
• To delete all the entered characters, move the cursor
to "RESET" and press the [SEL] button.
c
Move the cursor to "POSI" and press the [SEL] button
after title entry.
→ The display positioning screen appears and the
entered camera title blinks.
v
Use the [g], [h], [e] and [f] buttons to decide the
title position, and hold down the [FREEZE
button for 2 seconds or more.
→ The display position is determined and the title
creation screen appears again.
MENU ]
17