Troubleshooting - Zodiac MX 8 Montage- Und Gebrauchsanleitung

If you experience a problem with your Zodiac MX™ 8, please follow the troubleshooting steps below to
rectify any performance problems. If further assistance is required, contact your retailer.
Problem
Cleaner does not move or moves slowly.
Cleaner's pattern of movement
does not cover entire pool.
Cleaner gets stuck at steps.
Cleaner won't climb walls.
Cleaner spends too much time on the walls. • Using Flow Tester as guide, reduce flow to the second
For further information please contact your retailer.
20 20

Troubleshooting

Solution
• Confirm that the main drain is closed.
• Use Flow Tester to verify correct flow.
• Check for debris trapped in the drive motor.
Backwash filter and empty pump basket.
• Check for air in system. If water level in pump basket
drops or you see excessive air bubbles in the pump
basket or coming from the return lines, there is air
in the system. Check hose connections, tighten all
fittings at pump and check o-ring at pump basket
for wear.
• Check that the cleaner is not clogged with debris.
• Use Flow Tester to verify correct flow.
• Ensure return line fittings are directed downwards.
• Make sure there are no kinks in the hoses and
that they are not coiled. Lay in sun to straighten
if necessary. Is your hose long enough: add hose
sections if necessary.
• Verify correct hose float positioning.
• Observe cleaner for 5 plus minutes and ensure
that each drive track is periodically reversing
direction.
• Confirm proper hose length.
• Observe cleaner for more than five minutes
and ensure that each drive track is periodically
reversing direction.
• Ensure the swivel on top of the cleaner rotates freely.
• Use Flow Tester to verify correct flow.
• Confirm correct hose length. Shorten if necessary.
• Using Flow Tester as guide, increase flow to cleaner.
• Verify correct hose float positioning.
setting.
• Verify correct hose float position.