Page 10
Resetting to the Factory Default Settings
This will reset all parameters, including the IP address, to the Factory Default settings:
1. Disconnect power from the camera.
2. Press and hold the Control button (on the underside of the camera) and reconnect power.
3. Keep the button pressed until the Status Indicator displays yellow (this may take up to 15
seconds), then release the button.
4. When the Status indicator displays green (which can take up to 1 minute) the camera is
reset to the factory default settings.
5. Re-install the network camera using one of the methods described in this document.
More information
For more information, please see the AXIS 210/211/211A User's Manual, which is available on
the CD included in this package. Updated versions can be obtained from www.axis.com
AXIS 210/211/211A Installation Guide