Control Panel And Functions; Remote Control And Functions; Cleaning And Maintenance - Master BCF 230RB Bedienungs- Und Wartungsanleitung

en
IMPORTANT: The cooler is equipped
with a water drain, located at the base
of the appliance. Depending on the
setting, the cooler will drain the water
from the tank completely, in order to
prevent water stagnation. In any case,
it is recommended to drain the water
from the tank frequently.
During the winter season or in the
event of a long period of inactivity,
drain the circuit and water tank
completely.
NOTE: It is recommended to drain
the water from the tank before each
shutdown.
►4.1. CONTROL PANEL AND
FUNCTIONS
(Pic. 9)
►ON/OFF: Is used to turn the cooler on
or off.
►ARROW ↑↓: Increases or decreases
the ventilation speed.
►COOL: Enables or disables the cooling
mode.
►FAN: Enables the ventilation mode
only.
►SWING (Set-up): The function enables
or disables the automatic swing of the
fins to direct the air flow.
►DRAIN: Drains the water from the tank.
NOTE: When the control panel display
shows the icon "TANK" (flashing),
accompanied by a beep, it means that
the tank is empty and must be refilled
again to reactivate the COOL function.
►4.2. REMOTE CONTROL AND
FUNCTIONS
(Pic. 10)
►ON/OFF: Is used to turn the cooler on
or off.
►ARROW ↑↓: Increases or decreases
the ventilation speed.
Figures and texts of this book are protected by COPYRIGHT.
►COOL: Enables or disables the cooling
mode.
►VENT (FAN): Enables the ventilation
mode only.
►SWING (Set-up): The function enables
or disables the automatic swing of the
fins to direct the air flow.
►DRAIN: Drains the water from the tank.
►LIGHT: Activates the light on the
display.
►HOUR and MINUTE: Adjusts the time
on the remote control.
►4.3. SWITCH-OFF
►4.3.1. Drain the water from the tank
using the DRAIN function.
►4.3.2. Press the ON/OFF button to
switch the cooler off (the continuous
ventilation for a few minutes allows the
evaporation panels to dry).
►4.3.3. When the cooler is not used,
disconnect the electrical power supply
and the water supply.
►►5. CLEANING AND
MAINTENANCE
WARNING: BEFORE CARRYING OUT
ANY MAINTENANCE OR REPAIRS,
DISCONNECT THE APPLIANCE FROM
THE MAINS POWER AND WATER
SUPPLY.
Depending on the environment where
the appliance is used, dust, dirt, etc. can
affect the performance of the cooler. We
therefore recommend cleaning (never
clean with a high pressure water jet) the
outside of the cooler with a soft cloth,
removing any obstructions from the air
vents.