Installation; Power Cord - Faro MAIA Gebrauchsanleitung

INSTALLATION

Dental Lamp "MAIA", version S/TS
Check that the packaging contains the following components:
- Dental lamp (requested version)
- Envelope with lever + key
- Operating Manual
Clean the device before use
(see section Cleaning the device)
The device must be installed by specialised technicians.
Disconnect power supply during installation.
Lamp assembly, dental chair version
- Install the lamp by inserting the terminal lamp pin into the specific hole on the dental chair.
Long arm 855 mm
Long arm 550 mm

1) POWER CORD:

the bare minimum length for the connection
- LAMP WITH TRANSFORMER; it must be directly powered by the power-line
voltage corresponding to characteristics printed on the information plate or in the
technical specifications of the manual.
- Ensure that the main switch complies with IEC/EN 61058 standards.
- LAMP WITHOUT TRANSFORMER; it must be powered by low voltage alternate
current (17 - 24V AC) using a safety transformer that meets EN 60601-1 standards.
Fitting the ceiling – wall – floor light
- The applications are not supplied with the lamp.
CEILING
40°
50°
750
L=H-1700-20
- For fitting the individual applications follow the relevant installation manual.
CONNECTIONS
ANd
SAFE WORKING LOAD MINIMUM BREAKING LOAD
2.92 Kg
2.56 Kg
in the version without transformer be sure to keep no more than
WALL
40°
50°
23.5 Kg.
20.5 Kg
FLOOR
750
40°
50°
19