Onboard Headers And Connectors - ASROCK K7VT4A+ Bedienungsanleitung

2.6 Connectors
Connectors are NOT jumpers. DO NOT place jumper caps over these
connectors. Placing jumper caps over the connectors will cause perma-
nent damage of the motherboard!
Connector
FDD Connector
(33-pin FLOPPY1)
(see p.7 item 13)
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE Connector (Blue)
(39-pin IDE1, see p.7 item 8)
IDE1
PIN1
connect the blue end
to the motherboard
Note: If you use only one IDE device on this motherboard, please set the IDE
device as "Master". Please refer to the instruction of your IDE device vendor
for the details. Besides, to optimize compatibility and performance, please
connect your hard disk drive to the primary IDE connector (IDE1, blue) and
CD-ROM to the secondary IDE connector (IDE2, black).
USB 2.0 Connector
(9-pin USB45)
(see p.7 item 17)
Infrared Module Connector
(5-pin IR1)
(see p.7 item 18)
Figure
FLOPPY1
Pin1
Secondary IDE Connector (Black)
(39-pin IDE2, see p.7 item 7)
80-conductor, ATA 66/100/133 cable
USB_PWR
P-5
P+5
GND
DUMMY
1
GND
P+4
P-4
USB_PWR
IRTX
+5V
DUMMY
1
GND
IRRX
1 5
Description
the red-striped side to Pin1
IDE2
PIN1
connect the black end
to the IDE devices
ASRock I/O TM
default USB 2.0 ports on the rear
panel. If the rear USB ports are
not sufficient, this USB 2.0
connector is available to support
2 additional USB 2.0 ports.
This connector supports an
optional wireless transmitting
and receiving infrared module.
provides you 4