Safety Warnings; Installation - SCAN domestic K 62 Bedienungsanleitung, Montageanleitung

1. If the cable is damaged or needs replacing, this should be done by an
after-sales technician using the proper tools, so as to avoid any accidents.
2. If the appliance is being connected directly to the mains supply, an omnipolar
circuit breaker must be installed with a minimum gap of 3mm between the
contacts.
3. The installer must ensure that the correct electrical connection has been made
and that it complies with safety regulations.
4. The cable must not be bent or compressed.
5. The cable must be checked regularly and only replaced by a properly qualified
person.

Safety Warnings

Your safety is important to us. Please read this information before using your
cooktop.

Installation

Electrical Shock Hazard
• Disconnect the appliance from the mains electricity supply before carrying
• out any work or maintenance on it.
• Connection to a good earth wiring system is essential and mandatory.
• Alterations to the domestic wiring system must only be made by a qualified electrician.
• Failure to follow this advice may result in electrical shock or death.
Cut Hazard
• Take care - panel edges are sharp.
• Failure to use caution could result in injury or cuts.
Important safety instructions
• Read these instructions carefully before installing or using this appliance.
• No combustible material or products should be placed on this appliance at any time.
• Please make this information available to the person responsible for installing the appliance
as it
• could reduce your installation costs.
• In order to avoid a hazard, this appliance must be installed according to these instructions for
installation.
• This appliance is to be properly installed and earthed only by a suitably qualified person.
• This appliance should be connected to a circuit which incorporates an isolating switch providing
full disconnection from the power supply.
• Failure to install the appliance correctly could invalidate any warranty or liability claims.
17