Klippan Triofix Handbuch Seite 18

Forward faced with ISOFIX attachment
9-18 kg B1
Fastening the base, note pictures 1-5
Install the TRIOFIX seat to the base so that the rear side
fastening pipe of the seat fits into the fastening point
rear of the base. Push the seat forward at which time
the larger locking indicator of the seat will show green.
Then press the seat downwards so that the smaller
indicator on the seat also shows green. When the seat is
properly installed the indicators will no more show any
red colour.
Push the seat tight onto the car seats backrest.
Adjust the height of the supporting leg by pulling out
the adjusting knob, make sure the leg sits firmly on the
floor.
Position the child into the seat, note pictures 12-18
Detaching the seat
Detach the TRIOFIX seat from the base by pressing both
of the opening clasps on the seat as you lift the seat
from its backrest.
Forward faced with the cars 3P belt
9-18 kg (24-25, 29-35)
Place the ISOFIX base A10614 on the car seat as shown
in the picture.
Attach the TRIOFIX seat onto the base,
Note pictures 24 and 25
Open the velcro on the backrest of the seat.
Detach the seat clothing from the side of the backrest
and thread the safety belt under the clothing and the 5-
point belt of the seat, see picture 32.
Lock the car safety belt and tighten the lap-belt.
Tighten the shoulder belt and thread it under the
fastener for the safety belt
(1-5, 12-18, 24-28)
24
25
26
27
28
29
30
31
32
33
34
Put the clothing back on and fasten the velcro.
Child into the seat, note pictures 12-18
TRIOFIX as safety belt seat
Using 3-point belt, ISOFIX and base A10614
(1-5, 12-18, 24, 36-42)
Fastening the base, note pictures 1-5
Detach the clothing of the backrest: start with the tapes
and then loosen the sides.
Put the seat belts under the clothing.
Place the locking clasps into the holes on both sides of
the seat.
Put the clothing of the backrest back on.
Place the lock of the TRIOFIX seat into its hole under the
clothing.
Install the TRIOFIX seat to the base, note picture 24
Put the child into the seat, fasten the 3-point safety belt
of the car.
Thread the car's 3-point safety belt's shoulder belt
through the steering mount by the headrest of the
TRIOFIX seat. Adjust the headrest on suitable height for
the child.
Forward faced
TRIOFIX as safety belt seat using 3-point belt
without base
15-36 kg (43-44)
Put the TRIOFIX seat on the carseat, place the child into
the seat and fasten the car's safety belt. Thread the
car's 3-point safety belt's shoulder belt through the
steering mount by the headrest of the TRIOFIX seat.
Washing instruction
35
15-25kg
36
37
38
39
40
41
42
43
44