Chapter 7 Battery Status - Berger & Schroter IR518C Bedienungsanleitung

Chapter 7 Battery Status

IR518C thermal imager is power supplied by 2 units of replaceable and rechargeable Ni-MH
batteries, average operation time is 2 hours.
7.1 Battery charging method:
1) Aim the batteries electrode to the charger's electrode, and insert the battery into the charger.
Please pay attention to the inserting direction and position
2) Insert the 100-240VAC/9VDC adaptor plug into the AC charge socket. Connect the AC adaptor
cable to the 100～240VAC socket to start charging
3) When start the charging, the red and blue indicator will flicker alternatively.
4) In the process of charging, the red indicator is lightening, when fully charged, the blue indicator is
lightening.
5) It's normal that the AC adaptor will get heat during the charging process.
If the IR518C meets troubles please check the items listed below first, if the troubles beyond those
ones please contact us as soon as possible.
No. Trouble
1 The Thermal Imager can
not be turned on
2 The image is blurry
3 The image is too dark
or too bbright
4 No image output
AC adapter（Input：110-240VAC Output：9VDC）
Reason/Measure
No battery or lack of power; remove battery an install a fully
charged on.
Battery bad connection; reinstall the battery and tighten the
battery cover.
Switch off the system, and reboot it after 20 seconds.
Adjust focus till image clear.
Perform NUC function manually.
Adjust brightness and contrast manually or set to auto
brightness/contrast mode.
Display equipment connection problem or video cable
connection problems
IR518C Standard Packing List
N ME
IR518C Thermal Imager
Power/video/USB/RS232 cable
User manual
Equipment case
Voerder Straße 83 - 58135 Hagen - Tel. 02331-62400-0
20
QTY
1
1
1
1
1