Berger & Schroter IR518C Bedienungsanleitung Seite 15

5.2 Quick start guide
1) After careful checking，press for
4) Manually turn the oculars until you see the clear image on the screen.
5) The Thermal Imager will do non-uniformity-calibration automatically.
6) Short press
7) Aim the thermal imager to the target and observe.
8) Imaging:
a) Rotate the viewfinder until the target can be clearly observed.
b) Aim the Thermal Imager to the target.
c) The default mode is AUTOMATIC MODE which provides user with a clear image after simply focu-
sing. User can also adjust the brightness and contrast to get a qualified satisfying image.
Adjust the focus manually to get clear image.
Note: When human eye left the eye detector, the imager will enter stand-by mode, when eyes get
close to the eye detector, the OLED will lighten again!
9) Function Brief: Detailed button operation instructions such as Brightness and Contrast adjustment,
Polarity selection, cursor choosing and checking, setting language and button instruction, parameters
save, freeze, save and playback pictures, record and playback infrared video, focus adjustment, non-
uniformity calibration and etc functions, please refer to OPERATION INSTRUCTIONS in the next
section.
10) Power-off: When operation completed, firstly put back the lens cover, then press and hold the
power button till the shut-down progress bar on the screen reach its right end. After that, remove the
cables from the sight by holding the lock pin on the cable and pulling it out. Do not pull the cable by
force, otherwise damage may occur！
2) Starting-up image isas following picture:
3) Self-checking process is shown on the screen.
to calibrate the imager if there is any non-uniformity occurs during the operation.
5 sec to power on the imager.
15