Operation; Before You Start - Velleman CAMIP21 Bedienungsanleitung

P roc eed as follows:
1
T ake the hole meas urements based on the c amera s tand. P re-drill a hole with the 5 mm drill
bit and drill the final hole with the 1 5 mm bit. N ext, plac e a nylon plug (inc luded) in eac h hole.
A ls o provide a hole for the power c able.
2
Sec ure the c amera s tand on the s urfac e us ing the inc luded s crews and a #2 P hillips
s c rewdriver. M ake s ure not to overtighten the s crews as this may damage the c amera s tand.
3
L oos en the thumbs crew. A djus t the proper angle and s ecure with the T - bolt.
7.

Operation

7.1

Before You Start


Before c onnec ting your CAMIP21 c amera to the power s ourc e, firs t
c onnec t it to your Wifi router us ing the inc luded E thernet c able.

A fter the c amera is c onnected to the router, c onnec t it to the power
s ourc e and wait until both the red and green L E D s flash. D o not begin
the s etup proc ess until both L E Ds become s teady (roughly 4 5 s econds).

Follow the s teps in the following pages to c omplete the s etup.
V . 01 – 04 /02 /2015
CA MIP21
A TTENTION
5 ©V elleman nv