Cleaning Instructions - Philips Respironics Wisp Gebrauchsanweisung

Before Use Read and Understand the Instructions Completely.
‡ Hand wash the entire mask a.
‡ Wash your face. Do not use moisturizer/lotion on your hands or face.
‡ Inspect the mask. Replace the cushion A if hardened or torn, or any parts that are broken.

Cleaning Instructions

Hand wash the mask before first use and daily. The headgear GH should be hand washed weekly,
or as needed. The headgear does not need to be removed for daily cleaning of the mask.
1. Hand wash the mask and headgear in warm water with a liquid dish washing detergent.
Cautions:
Do not use bleach, alcohol, cleaning solutions containing bleach or alcohol, or cleaning
solutions containing conditioners or moisturizers.
Any deviation from these instructions may impact the performance of the product.
Inspect the mask for damage or wear (cracking, crazing, tears, etc). Discard and replace any
components as necessary.
2. Rinse thoroughly. Air dry completely before use. Make sure the mask is dry before use. Lay the
headgear flat or line dry. Do not place the headgear into the dryer.
Dishwashing Instructions
In addition to hand washing, the mask may be cleaned in the dishwasher once a week.
Caution: Use a liquid dish washing detergent only to wash the mask.
1. Remove the headgear. Do not wash the headgear in the dishwasher.
2. Separate the cushion A and the frame F and wash (clear frame only) in the top shelf of the dishwasher.
3. Air dry. Make sure the mask is dry before use.
Warning: Inspect the mask for damage or wear (cracking, crazing, tears, etc). Discard and replace any
components as necessary.
Institutional Disinfection
For multi-patient use in the hospital/institutional environment, use the Disinfection Guide to reprocess the mask
between patients. These instructions can be obtained by visiting us online at www.philips.com/respironics or
by contacting Philips Respironics Customer Service at 1-724-387-4000 or Respironics Deutschland at +49 8152
93060.
Achieving the Right Fit
Note: Do not overtighten the headgear.
Before Putting on the Mask
1. Sizing: Select the cushion that fits the width of your nose without blocking your nostrils. The top
of the cushion may sit between the bridge and tip of your nose.
Putting on the Mask
2. Headgear tab or clip G: Disconnect one, or both b. Peel the headgear tabs away from the
headgear strap and pull through slot in the mask frame or if using the clip twist outward.
3. Headgear: Pull the headgear on over your head c.
4. Cushion: Place the cushion over your nose.
5. Headgear tab or clip: Thread tab through slot in the mask frame or press the clip against the
headgear slot to reattach d.
Adjusting the Mask
6. Headgear: Peel the headgear tabs away from the headgear straps then press tabs against the
headgear straps to reattach e.
Connect the side strap H to the headgear tab located at the base of the crown strap.
Connect the bottom strap G tab near the back of the headgear.
7. Headgear: Adjust the side straps evenly f.
8. Headgear: Adjust the bottom straps evenly g.
The mask should rest comfortably against your face h.
2