Technical Data; Safety Instructions; Bezpečnostní Pokyny - Uponor Smatrix Wave Pulse Kurzanleitung

Technical data

(869 MHz)
IP20 T45
IP20 T45
IP20 T40
IP20 T50
IP20 T45
802.11 b/g/n @ 2.4Ghz,WPA & WPA2
IP20 T45
Uponor Smatrix Wave PULSE
EN Installation and operation manual
+
+70 °C
...
-20 °C
: ERP IV
+65 °C
ERP IV
...
-10 °C
+50 °C
ERP IV
...
-10 °C
+70 °C
ERP IV
...
-20 °C
+70 °C
ERP IV
...
-20 °C
+70 °C
...
-20 °C
CD0000130
PDF
EN

Safety instructions

This quick guide to serves as a reminder for experienced installers.
We strongly recommend reading the full manual before installing the
control system.
Warning!
: ERP VIII
The Uponor system uses 50 Hz, 230 V AC power. In case
of emergency, immediately disconnect the power.
Warning!
Electrical installation and service behind secured 230
V AC covers must be carried out under the supervision of
a qualified electrician.
Warning!
The transformer module is heavy and might detach if the
controller is held upside down without the cover on.
Caution!
To avoid interference, keep installation/data cables away
from power cables of more than 50 V.
Caution!
If communication difficulties exist, Uponor recommends
relocating the antenna to a more optimal position, and not
installing Uponor radio sources to close to each other (at
least 40 cm apart), for solving exceptional problems.
Caution!
Ensure that each actuator is connected to the correct
channel so that the thermostats are controlling the correct
loops.
Connect only one actuator for each channel. Channels 01
and 02 have double outputs (a and b) for two actuators.
Caution!
If more than one controller is available in the system,
HTML
register the thermostat as a system device to the master
controller.
Caution!
The switches in public the thermostat must be set before
the thermostat is registered.
Caution!
The switches, in the public thermostat, must be set to
one of the available functions, otherwise it cannot be
registered.
Note
Registration of at least one thermostat must be done
before registering a system device.
CZ Bezpečnostní pokyny
Tento stručný průvodce slouží jako referenční příručka zkušeným
instalačním technikům. Důrazně doporučujeme prostudovat si před
instalací systému regulace celou příručku.
Výstraha!
Systém Uponor využívá napájení 230 V~, 50 Hz.
V nouzových případech napájení neprodleně odpojte.
Výstraha!
Elektrická instalace a zásahy za zabezpečenými kryty
230 V~ musí probíhat pod dohledem kvalifikovaného
elektrotechnika.
Uponor Smatrix Wave PULSE l Quick guide l 3