Preliminary Operations; Setting Up The Machine - Facem Tre Spade Bedienungsanleitung

• In the case of damage to the power cord,
it must be replaced by the manufacturer
or its Service Dept. or by a skilled person
aware of the risks inherent in operations on
electrical appliances.
• The appliance can be used by children not
younger than 8 or by people with low men-
tal, phisical or sensorial abilities either than
without expereince or knowledge of such
appliances. Everyone who uses the applian-
ce has to be informed about related risks
and receive proper instructions. Children
do not have to play with the appliance. Cle-
aning must not be done by children without
proper surveillance.
• Do not operate the machine without in-
troducing any food to be processed; even a
short "void" functioning compromises the
involved components of the product and
leads to motor overheating. Relevant da-
mages to the machine itself are often irre-
versible and are not covered by guarantee.
INSTRUCTIONS FOR USE
AND MAINTENANCE
DESCRIPTION
The machine consists in two main parts:
a) A power unit or motor assembly
(MT),whose function is to supply motion; it
is equipped with an electric motor with
start/stop switch and power flex, drive and
base to rest the machine on the workbench.
Except for extraordinary maintenance,
which should be carried out only by the
manufacturing company, no other action
needs to be taken. The only operations to be
performed should be those connected with
the instructions for use.
b) A processing unit composed by several
elements described later on which must be
connected with the motor assembly (MT) in
order to carry out its function.
TRE SPADE TRE SPADE

PRELIMINARY OPERATIONS

Get the power unit ready by resting it on
the workbench, then take the meat mincer
body assembly to pieces by completely un-
screwing the threaded crown (A), then draw
out perforated plate (P), grinding blade (B)
and screw (E) from the body (C).
We recommend that all the components de-
scribed at this stage, also including presser
(L) and feed hopper (T), should be carefully
washed and dried.
Of course the motor assembly (MT)must not
be washed.

SETTING UP THE MACHINE

• Fit the body (C) into its seat in the motor as-
sembly (MT) after partially unscrewing the
hand wheel (V). Make sure that the body
has been fitted with the meat-supply ope-
ning turned up and that it has been driven
into its seat up to the end; lock into place
by turning the hand wheel (V) to the end
without forcing the locking position too
much.
• If the body has been properly assembled, it
cannot be taken out or revolve in its seat.
• Fit horizontally the screw (E) in the body (C)
on the side of the grooved shaft driving it
on the bush (D) (a component placed inside
the body(C)).
• At this stage, if necessary, slightly rotate the
screw (E) so that the insertion of the clutch
into the motor drive will be made easier.
• Fit in sequence in the pin with the square
dragging part jutting out from the screw:
the grinding blade (B) with the cutting edge
facing outside, and the perforated plate (P)
with the flat side facing the cutting edge of
the blade . When fitting in the blade, make
sure that the square dragging part is pro-
perly inserted.
• Check if the outside notch in the plate is
positioned in connection with the special
(see Fig. 1)
(see Fig. 1)
Made in Italy Made in Italy