Technical Specifications - Velleman CAMSET27 Bedienungsanleitung

Vorschau ausblenden

Seite von 19

/ 19
Inhalt
Inhaltsverzeichnis
Lesezeichen

Inhaltsverzeichnis

Verfügbare Sprachen

Installation

Refer to the illustrations on page 2 of this manual.

• Make sure the vehicles' engine is off and power is removed from the electrical

system. Disconnect the battery and remove the ignition key from the ignition

switch.

• Mount the LCD [A] with the mounting bracket [B] on the dashboard using the

double sided tape on the bottom of the bracket. Make sure the driver has a

clear view on the monitor.

• Connect the monitor cable [D] to the monitor. The connector fits in only one

way, do not force.

• Guide the video cable [C] to the back of the car where the camera will be

mounted.

• Drill a hole (Ø28mm) in the bumper (drill not included).

• Insert the cables [5, 6] and the camera [G] into the hole. Depending on the

location of the camera, use the adjustment rings to level the camera with the

surface of the bumper. Use the nut to secure the camera. Do not tighten it yet.

• Connect the video cable [C] to the camera [5, yellow]; connect the other end

to the monitor cable [D2, yellow].

• Connect the red wire [3] of the monitor cable [D] to the cars +12V electrical

circuit, at a location where there is only power once the ignition key is turned

(run circuit).

• Connect the black wire [4] of the monitor cable [D] to ground (GND).

• Connect the red wire [3] of power cable [E] to the reverse light circuit (+12V).

• Connect the black wire [4] of power cable [E] to ground (GND).

• Connect the other end of power cable [E] to the camera [6, black].

• Restore power to the vehicles' electrical system; insert the ignition key in the

ignition switch and turn.

• The monitor will now show the image of the camera. Verify that this image is

upright. If not rotate the camera until it is, than secure it by tightening the nut

[F].