Maintenance - GreenWorks 2502007 Bedienungsanleitung

■ Always be sure of your footing. A slip and fall can
cause serious personal injury. If you feel you are losing
your balance, release the power lever immediately.
■ Do not mow near drop-offs, ditches, or embankments;
you could lose your footing or balance.
EMPTYING THE GRASSBOX
See figure 10.
■ Stop mower, allow blade to completely stop, and
remove isolator key.
■ Lift the rear door.
■ Lift the grassbox by its handle to remove from mower.
■ Empty grass clippings.
■ Lift the rear door and reinstall the grassbox as
described earlier in this manual.

MAINTENANCE

Before performing any maintenance, make sure the
mower battery and isolator key are removed to avoid
accidental starting and possible serious personal injury.
When servicing, use only authorised replacement parts.
Use of any other parts may create a hazard or cause
product damage.
Keep the motor and battery compartments free from
grass, leaves or excessive grease. This will help reduce
the risk of fire.
GENERAL MAINTENANCE
Before each use, inspect the entire product for damaged,
missing, or loose parts such as screws, nuts, bolts, caps, etc.
Tighten securely all fasteners and caps and do not
operate this product until all missing or damaged parts are
replaced. Please call Greenworks tools customer service
for assistance. Avoid using solvents when cleaning
plastic parts. Most plastics are susceptible to damage
from various types of commercial solvents and may be
damaged by their use. Use clean cloths to remove dirt,
dust, oil, grease, etc.
English (Original Instructions)
WARNING
WARNING
WARNING
Do not at any time let brake fluids, gasoline, petroleum-
based products, penetrating oils, etc., come in contact
with plastic parts. Chemicals can damage, weaken, or
destroy plastic which may result in serious personal
injury.
Periodically check all nuts and bolts for proper tightness to
ensure safe operation of the mower.
Wipe the mower clean with a dry cloth occasionally. Do
not use water.
LUBRICATION
All of the bearings in this product are lubricated with a
sufficient amount of high grade lubricant for the life of the
unit under normal operating conditions. Therefore, no
further bearing lubrication is required.
Always protect hands by wearing heavy gloves and/or
wrapping the cutting edges of the blade with rags and
other material when performing blade maintenance.
Contact with the blade could result in serious personal
injury.
Do not lubricate any of the wheel components.
Lubrication may cause the wheel components to fail
during use, which could result in serious personal injury
to the operator and/or mower or property damage.
REPLACING THE CUTTING BLADE
See figure 11-12.
NOTE: Only use authorised replacement blades. Replace
worn or damaged blades and bolts in sets to preserve balance.
■ Stop the motor and remove the switch key. Allow
blade to come to a complete stop.
■ Remove the battery pack.
■ Turn the mower on its side.
■ Wedge a block of wood between the blade and mower
deck to prevent the blade from turning.
■ Loosen the blade bolt by turning it counterclockwise
(as viewed from bottom of mower) using a 27 mm
wrench or socket (not provided).
■ Remove the blade bolt and blade.
■ Place the new blade on the shaft. Ensure blade is
properly seated with shaft going through center blade
hole and the two blade posts on the fan inserted into
their respective holes on the blade. Make sure it is
18
WARNING
WARNING
WARNING