Optional External Supports; Wiring - AKO -52042 Bedienungsanleitung

6.1.- Optional external supports

The alarm can be affixed to the wall by means of the optional supplied external supports.
Figure 7
-Insert the supports in the upper rear part of the alarm lodgings and affix them using the included screws (fig. 7).
-Affix the alarm to the wall using two 4x35 screws + two 6 mm plugs (Not included) (fig. 8).

7.- Wiring

Always disconnect the power supply to do the wiring.
The power circuit should be equipped with a switch for its disconnection of at least 2 A, 230 V, situated near
the appliance.The power supply cable will be H05VV-F or H05V-K. The section tobe used will depend on
current local regulations, but should never be less than 1 mm .
Cables for wiring the relay contact should have an adequate section depending on the unit to be connected.
Make sure you have connected the batteries before starting-up the unit.
Reset
button
DI4
DI3
Digital
inputs
DI2
DI1
Battery
connector
Mini-USB
connector
Figure 8
m
7 0 m
2
connector
SIM card slot
18
Antenna
100-240 V~
50/60 Hz