Stiga SILENT 33 Gebrauchsanweisung Seite 24

GB
TOOLS FOR ASSEMBLEY
WHEELS/CUTTING HEIGHT (fig. 4)
1. Insert the wheel bolt A in the hub cap B.
2. Snap-on the centre cup C.
3. Fit the wheel in one of the fixing plate's four po-
sitions.
4. Tighten securely by hand using the finger-grip
holes in the hub cap.
NOTE! The same cutting height should be set on all
four wheels.
STEERING TYPE I (fig. 1)
1. Insert a steering tube into the bracket on the left-
hand side as illustrated.
2. Slide in the steering's upper section.
3. Turn the entire steering in the opposite direction
as illustrated.
4. Insert the other steering tube into the upper sec-
tion.
5. Insert the steering tube into the bracket on the
right-hand side.
6. Turn back the entire steering into the upright po-
sition.
7. Fit the screws. Tighten securely.
8. Secure the electrical cable into the cable holder.
9. Fix the electrical cable using a cable tie.
STEERING TYPE II (fig. 2)
1 . Insert the steering shaft into the handlebar arch.
2. Fit the screws. Tighten securely.
3. Press the steering sockets into the holes in the
chassis.
4. Fit the screws. Tighten securely.
5. Attach the handlebar to the steering sockets us-
ing screws, washers and locking knobs. The han-
dlebar can be tilted forward by loosening the
locking knobs slightly. The mower will then take
up less space during transportation.
6. Secure the electrical cable into the cable holder.
24
ENGLISH
7. Fix the electrical cable using a cable tie.
STEERING TYPE III (fig. 3)
1. Make sure that the holes in the handle are on the
right side. Align the pins on the switch with the
holes in the handle. Make sure that the cable
does not get caught and that the button is on the
outside. Carefully clamp the mount so that it fits
securely around the handle.
Install the screws. Tighten properly.
2. Press the handle mounts down into the holes in
the chassis.
3. Install the screws. Tighten properly.
4. Install the handle on the handle mounts with
screws, washers and locking wheels. By un-
screwing the locking wheels a little, the handle
can be folded forward. The mower then takes
up less room e.g. during transport.
5. Secure the power cable with cable ties.
GRASS COLLECTOR (fig. 5)
Snap-together the grass collector's upper and lower
parts.
Open the cover on the machine and hook the grass
collector onto the chassis.
NOTE! The lawn mower can be used without the
grass collector. The grass will then collect in a bead
behind the machine.
USING THE MOWER
CONNECTION (fig. 6, 7)
Only use an extension cable that is approved for
outdoor use with a maximum length of 50 m. It
should not be lighter than type 245 IEC 53
(H05RR-F) or 227 IEC 53 (H05VV-F). If you are
unsure of anything, please contact your dealer.
To increase safety the lawn mower should be con-
nected to an earth-fault breaker.
Support the extension cable in the cable support on
the steering.
START/STOP (fig. 8)
Start the mower on flat, solid ground. Do not start
in long grass. Press on the steering so that the front
wheels lift slightly from the ground to reduce grass