Installation Instructions - Victoria Arduino Venus Century Technische Bedienungsanleitung

INSTALLATION INSTRUCTIONS

After making sure nothing is missing in the
packaging, fit the 2 missing feet and position
the machine in the housing provided.
Connect the water cleaner inlet up to the
water supply point; connect the cleaner outlet
pipe b to the pump inlet; next connect the sup-
ply pipe c to the pump outlet. Finally fit the
drain pipe d provided to the connection point
underneath the machine bed and secure the
seal using the special clip.
Position the cup-warming plate, the cup-war-
ming strip, the dome, the drain trays and final-
ly the eagle in the housings provided.
Next make sure the machine is level by means
of the adjustment feet.
Make sure the power supply system is compa-
tible with the details shown on the machine
identification plate.
Connect the power cable coming from the
machine to the pump and the power plug f to
a properly earthed power socket.
Avoid any bends and blockages in the pipes.
Make sure the drain is free and, if the power
cable provided is inadequate, use another with
the same cross section.
The machine must always be protected by
means of an automatic switch of adequate
power.
The company disclaims liability for any damage
to things or injury to persons caused by failure
to observe the applicable safety regulations.
STARTING UP
Turn the master switch from position 0 to posi-
tion 1 so the boiler can correctly fill up. To
reach suitable filling level, the machine may
have to be switched off several times and the
master switch returned to position.
1. The switch can only be moved to position 2
once maximum level has been reached.
After about 20 minutes, the machine will have
reached operating pressure. This is indicated on
the double-scale pressure gauge.
To change the operating pressure of the boiler
(and consequently the temperature) according
to the various requirements or characteristics
of the coffee used, simply lift the cup-warming
plate and adjust the pressure switch screw;
23