Velleman CAMSET21 Bedienungsanleitung Seite 4

Overview
5.
Refer to the illustrations on page 2 of this manual.
A input channel 1
B input channel 2
C input channel 3
camera 1 MIR/NOR
D
♦ ♦ ♦ ♦
I sunshield
J IR LEDs
K camera
N LCD display
O earphone jack
P AV jack
Q video select button
R decrease button
Installation
6.
• Install the camera on the back of the vehicle and guide the signal cable to the front.
• Mount the control unit under the dashboard. Do not cover the ventilation holes of the
unit.
• Mount the TFT monitor on the dashboard with the included mounting bracket, not too far
from the control unit (cable ±1.3m). Make sure the driver has a clear view on the monitor
when driving backwards.
• Connect the cable from the monitor to the monitor output [G] of the control unit.
• The control unit has 3 input channels. Connect the cable from the backing camera to
input channel 2 [B] of the control unit (middle connector). Note that the signal on this
input channel will automatically be displayed when reverse gear is selected.
• When applicable, another camera (not incl.) or device e.g. DVD (not incl.) can be
connected to either input channel 1 [A] or input channel 3 [C]. Note that the red
connector of the included adapter cable supplies +12VDC.
• It is also possible to connect an external video device (not incl.) to the video output [F].
• Make sure power is removed from the vehicles electrical system and the engine is off. Use
the included power cable (with plug) to power the control unit. First connect the red wire
(with fuse holder) to the +12VDC circuit of the car, then connect the black wire to
ground. The blue cable must be connected to the reverse gear circuit in such a way that
it gets power when reverse gear is selected.
• Re-apply power to the vehicles electrical circuit. The status LED [W] on the monitor
should turn red. If not, check all connections.
Operation
7.
All functions can be accessed both on the monitor and via the remote control.
• Switch on the monitor by pushing on the power button [U]. The status LED [W] turns
green. The monitor switches on automatically when reverse gear is selected.
• Select the video input channel with the video select button [Q]. When reverse gear is
engaged, the monitor will automatically switch to the signal on input channel 2 [B].
• Press the left arrow (⊳) button [R] to decrease or the right arrow ( ) button [T] to
increase the volume. Volume ranges from 0 to 40.
• Press the menu button [S] to enter the screen setup. Use the left arrow (⊳) [R] and
right arrow ( ) button [T] to change the current setting and press the menu button [S]
again to move to the next setting. The setup is saved and the menu closes automatically
after ±10 seconds of inactivity. Refer to the following table for all available settings.
00 (08/04/2009)
♦ ♦ ♦ ♦
view switch
Image can be shown mirrored if connected camera supports this function
CAMSET21
E camera 2 MIR/NOR
F video output
G monitor output
H power supply input
L light sensor
M mounting bracket
S menu button
T increase button
U power button
V IR receiver
W status LED
4
♦ ♦ ♦ ♦
view switch
Velleman
®