Stopwatch Mode - Velleman SW2 Bedienungsanleitung

SW2
Alarm On/Off
Hold B and C (see fig.) simultaneously to activate/deactivate the
alarm.
Calendar
Hold B to display the month, the date and the day of the week.
12/24 Hr-Mode
Select either the 12hr- or the 24hr-mode when setting the time.
Press A (see figure) three times to make the digits for the seconds
flash. Press B to reset the seconds. Press C to confirm the seconds
and make the digits for the minutes flash. Use B to set the minutes,
press C to confirm the minutes and make the digits for the hours
flash. Note that the digits will progress faster if B is held. Press
B again to advance the hours until the "A"-, the "P"- or the "H"-
symbol appears on the display: "A" and "P" stand for 12hr-mode, "H"
for 24hr-mode. Press A to return to the normal time display.
4.2

Stopwatch Mode

Press A once to activate this mode. Press B to start/stop the
stopwatch. Press C while the stopwatch is running to display the split
time and press again to display the timing again. Press C to reset the
stopwatch when it is not running.
Measurement of total elapsed time: Press B to start the
stopwatch. Press B again to stop it and press B again to restart the
stopwatch. The stopwatch will continue the count from where it was
stopped. Press B to stop the stopwatch and press C to reset it.
Split time measurement: Press B to start the stopwatch. The
stopwatch is still running off-screen when C is pressed to view the split
time. Press C to display the ongoing count on-screen again. Press B to
stop the stopwatch and C to reset it.
Comparing two competitors: Press B to start the stopwatch and
press C to display the time of competitor 1. The user should
consequently press B to display the time of competitor 2. Press C to
reset the stopwatch.
Press A to return to the normal display mode.
V. 03 – 15/01/2018 4 ©Velleman nv