Technical Data; Burner Equipment - Riello N10 Montage- Und Bedienungsanleitung

TECHNICAL DATA

Thermal power - Output
Fuel
Electrical Supply
Motor
Capacitor
Ignition transformer
Electric heater
Absorbed electrical power
Pump
Burner with EC marking in conformity with EEC directives: EMC 89/336/EEC - 2004/108/EC,
Low Voltage 73/23/EEC - 2006/95/EC and Machines 2006/42/EC.
The burner meets protection level of IP 40, EN 60529.
1 – Suction connector (G 3/8)
2 – Return connector (G 3/8)
3 – Pressure regulator
4 – Vacuometer attachment (G 1/8)
5 – Pressure gauge attachment (G 1/8)
6 – Equipment release button
7 – Combustion head adjustment screws
8 – Regulation thermostat
9 – Minimum contact thermostat
10 – Control pressure gauge
11 – Pressure gauge protection valve
12 – Fuel temperature control thermometer
13 – Pre-heater filter
14 – Terminal block
15 – Cable clamps
1440
51 – 114 kW –
Oil, max. viscosity at 50 °C: 38 mm
Single phase, 230 V ± 10%
1,25 A / 230 V
6,3 F
Primary 2 A / 230 V – Secondary 2 x 5 kV – 30 mA
No. 1 from 0.8 kW
1.1 kW
45 kg/h at 20 bar
Fig. 1
S7375
16 – Exhaust valve
17 – Air damper
18 – Screws fixing air damper

BURNER EQUIPMENT

Quantity
1
GB
4,5 – 10 kg/h
2
/s (5 °E)
~
50Hz
Description
2 Flexible oil pipes with nipples
2 Gaskets for flexible pipes
4 Screws and nuts for flange
1 Flange with insulating gasket
1 Nozzle
1 Hinge
1 Cable grommet
1 Screw and two nuts for flange
ENGLISH